Re: Armadillo gun question for Hugh

Hugh · 05-08-2002, 02:36 AM

Rick,

I bought the toggle already made up from Tom Heller. There is a small block soldered to the rear of the toggle to support the sight. The front mounting screw is tapped into the toggle, the rear elevation screw works normally.

http://boards.rennlist.com/upload/ArmadilloGunr.jpg

Hugh · 05-08-2002, 11:52 AM

Rick,

In soldering the guards on the knives I make, I have found that the solder-flux combo in paste form seems to work best. Second choice is Brownells Hi-Force 44.

05-09-2002, 12:41 PM

Here's an outfit that sells the silver solder paste in a syringe for $7.95. It's a lot cheaper than Brownells $25. They also sell other types of silver solder used in the jewelery trade. Hope this helps.

Starr Gems

05-08-2002, 02:36 AM	#1
Hugh RIP Join Date: Jun 2002 Location: Southeast Texas Swamp Posts: 2,460 Thanks: 2 Thanked 165 Times in 64 Posts	Re: Armadillo gun question for Hugh Rick, I bought the toggle already made up from Tom Heller. There is a small block soldered to the rear of the toggle to support the sight. The front mounting screw is tapped into the toggle, the rear elevation screw works normally. http://boards.rennlist.com/upload/ArmadilloGunr.jpg

05-08-2002, 11:52 AM	#2
Hugh RIP Join Date: Jun 2002 Location: Southeast Texas Swamp Posts: 2,460 Thanks: 2 Thanked 165 Times in 64 Posts	Re: adjustable sight dreaming Rick, In soldering the guards on the knives I make, I have found that the solder-flux combo in paste form seems to work best. Second choice is Brownells Hi-Force 44.

05-09-2002, 12:41 PM	#3
Brad Guest Posts: n/a	Silver solder supplier Here's an outfit that sells the silver solder paste in a syringe for $7.95. It's a lot cheaper than Brownells $25. They also sell other types of silver solder used in the jewelery trade. Hope this helps. Starr Gems

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode