Help with a luger replica

Major Tom · 12-05-2019, 10:07 AM

My friend has an Erma-Werke Model KGP68A kal. 9 kurz/.380 pistol.
Disassembly was fairly easy, but, assembly real difficult. Has to do with lining up the rear pin that holds together 2 springs. He also had a problem with chambering a round; seems the breach block would not go far enough to the rear to push a round in the chamber. Hence the disassembly. If someone could offer some advise, it would be appreciated. You Tube has been no help.

12-05-2019, 10:07 AM	#1
Major Tom User Join Date: Jan 2017 Location: S.E. Iowa Posts: 484 Thanks: 533 Thanked 227 Times in 124 Posts	Help with a luger replica My friend has an Erma-Werke Model KGP68A kal. 9 kurz/.380 pistol. Disassembly was fairly easy, but, assembly real difficult. Has to do with lining up the rear pin that holds together 2 springs. He also had a problem with chambering a round; seems the breach block would not go far enough to the rear to push a round in the chamber. Hence the disassembly. If someone could offer some advise, it would be appreciated. You Tube has been no help. __________________ I Build Custom Pistol Boxes

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode