Trigger Bar Trouble

alee64 · 05-16-2008, 05:15 PM

I want to remove the SMALL pin in the sear, so that I can remove the spring and clean throughly. I know I must drive the pin out, but should the spring be depressed before tapping it out? or not? Andy

policeluger · 05-16-2008, 05:48 PM

The only way I have been able to remove the pin was mill it out and use a new pin......

John Sabato · 05-16-2008, 07:10 PM

Howard, I have successfully removed several of these pins with the correct size pin punch over a bench block with an appropriate sized hole under the pin... I never had one of them balk. Not sure why you had a problem.

Andy,

In answer to your question, no you don't need to depress the plunger to drive out the pin.

05-16-2008, 05:15 PM	#1
alee64 User Join Date: May 2008 Posts: 13 Thanks: 0 Thanked 0 Times in 0 Posts	Trigger Bar Trouble I want to remove the SMALL pin in the sear, so that I can remove the spring and clean throughly. I know I must drive the pin out, but should the spring be depressed before tapping it out? or not? Andy

05-16-2008, 07:10 PM	#3
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,154 Thanks: 3,003 Thanked 2,306 Times in 1,097 Posts	Howard, I have successfully removed several of these pins with the correct size pin punch over a bench block with an appropriate sized hole under the pin... I never had one of them balk. Not sure why you had a problem. Andy, In answer to your question, no you don't need to depress the plunger to drive out the pin. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*

05-16-2008, 05:48 PM	#2
policeluger RIP Join Date: Jun 2002 Location: Ca. Posts: 2,141 Thanks: 8 Thanked 89 Times in 54 Posts	The only way I have been able to remove the pin was mill it out and use a new pin......