** Storage Question **

KEN · 03-19-2002, 10:03 PM

I would like to ask the Forum a question, that may have been asked in the past. I currently store my pistols in a single plastic case, with foam liners, the typical cheap ones. I have used rem oil to coat them, and wipe them down, in the past, but now use Prestone Silicone Lubricant spray to coat them. I guess what I want to ask is this a good measure, or is there something else better out there. I do not want them to tarnish, rust, or the like. Any thoughts, what do all of you use? Thanks...Ken

03-19-2002, 10:07 PM

Many will cringe, but I had mine in this situation for years, I had oiled them well, and it was dry where they were stored in eastern washington, but I had them like this for years.

This was discussed recently and if you do a search on the forum for storing Lugers, you should find a thread or two on this very subject. This was within the last two weeks.

Ed

03-19-2002, 10:08 PM

Check this out...

http://communities.prodigy.net/sportsrec/gz-rust.html

MarkC · 03-19-2002, 11:00 PM

Great info!! But nothing beats a fireproof safe in a dry location in your home with a golden rod or similar dehumidifier stick. The price of a high quality safe is the same as an artillary luger rig! I always believe that access to firearms to unauthorized individuals is verboten! (This includes your drunken brother-in-law!!!)

Marvin · 03-22-2002, 08:16 AM

Ken,

Do a search and look at the previous postings on the subject, it will help a lot!

To me, one of the worst offenders is humidity in your area! If you live near the coast, watch them close, if you live in a desert area, they just don't rust quick. My area is not too bad with humidity except about an 8 week period in the summer and then the humidity is high, but if you use a quality rust preventative oil and check them often you will be OK.

One thing I don't like about the foam cases is that IF any moisture gets on the foam, and you close the case, the metal will rust from the contact with moisture. This is not to likely to happen, but it can! A soda can with condensation may accidetlu drip and you may not see it and it can do damage.

My recommendation is use a quality oil! Most good preventatives will do a good job. Some are a little better than others, but any oil will help. For long term storage in the cases you describe, I would put a light coat of RIG (Rust Inhibiting Grease) on the metal surfaces, and wrap the pistol in VIP paper. This does will give you great protection. To go one step further, instead of putting them in the foam cases, use the soft type case called "Bore-Stor". With the RIG, VIP paper, and the Bore Stor, they should never rust.

Marvin

03-19-2002, 10:03 PM	#1
KEN User Join Date: Jun 2002 Posts: 51 Thanks: 0 Thanked 4 Times in 2 Posts	Storage Question I would like to ask the Forum a question, that may have been asked in the past. I currently store my pistols in a single plastic case, with foam liners, the typical cheap ones. I have used rem oil to coat them, and wipe them down, in the past, but now use Prestone Silicone Lubricant spray to coat them. I guess what I want to ask is this a good measure, or is there something else better out there. I do not want them to tarnish, rust, or the like. Any thoughts, what do all of you use? Thanks...Ken

03-19-2002, 10:07 PM	#2
66mustang Guest Posts: n/a	Re: Storage Question Many will cringe, but I had mine in this situation for years, I had oiled them well, and it was dry where they were stored in eastern washington, but I had them like this for years. This was discussed recently and if you do a search on the forum for storing Lugers, you should find a thread or two on this very subject. This was within the last two weeks. Ed

03-19-2002, 10:08 PM	#3
The Shadow Guest Posts: n/a	: Storage Question Check this out... http://communities.prodigy.net/sportsrec/gz-rust.html

03-19-2002, 11:00 PM	#4
MarkC User Join Date: Jun 2002 Location: Boston, MA Posts: 478 Thanks: 1 Thanked 109 Times in 26 Posts	Re: : Storage Question Great info!! But nothing beats a fireproof safe in a dry location in your home with a golden rod or similar dehumidifier stick. The price of a high quality safe is the same as an artillary luger rig! I always believe that access to firearms to unauthorized individuals is verboten! (This includes your drunken brother-in-law!!!)

03-22-2002, 08:16 AM	#5
Marvin User Join Date: Jun 2002 Location: Upstate S.C. Posts: 1,132 Thanks: 0 Thanked 0 Times in 0 Posts	Re: Storage Question Ken, Do a search and look at the previous postings on the subject, it will help a lot! To me, one of the worst offenders is humidity in your area! If you live near the coast, watch them close, if you live in a desert area, they just don't rust quick. My area is not too bad with humidity except about an 8 week period in the summer and then the humidity is high, but if you use a quality rust preventative oil and check them often you will be OK. One thing I don't like about the foam cases is that IF any moisture gets on the foam, and you close the case, the metal will rust from the contact with moisture. This is not to likely to happen, but it can! A soda can with condensation may accidetlu drip and you may not see it and it can do damage. My recommendation is use a quality oil! Most good preventatives will do a good job. Some are a little better than others, but any oil will help. For long term storage in the cases you describe, I would put a light coat of RIG (Rust Inhibiting Grease) on the metal surfaces, and wrap the pistol in VIP paper. This does will give you great protection. To go one step further, instead of putting them in the foam cases, use the soft type case called "Bore-Stor". With the RIG, VIP paper, and the Bore Stor, they should never rust. Marvin

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode