I need help with a P08 slide stop problem

mrapaul · 12-25-2020, 12:18 AM

On reviewing the mess I got myself into, I am pretty sure I had the magazine in, which pushed up the hold open latch, when then moved the receiver, it trapped the HOL.....things went from bad to worse. I tried to remove the breach block but it was trapped, and then the pin wouldn't align
We ended up driving the receiver forward with a piece of wood to soften the tapping.. we used a lot of penetrating oil before hand
The springs, and everything are OK. No damage.....greatly relieved and thankful for the help on this forum

The take away....make sure the magazine out before any movement is attempted.....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-25-2020, 12:18 AM	#1
mrapaul User Join Date: Dec 2020 Posts: 9 Thanks: 0 Thanked 1 Time in 1 Post	On reviewing the mess I got myself into, I am pretty sure I had the magazine in, which pushed up the hold open latch, when then moved the receiver, it trapped the HOL.....things went from bad to worse. I tried to remove the breach block but it was trapped, and then the pin wouldn't align We ended up driving the receiver forward with a piece of wood to soften the tapping.. we used a lot of penetrating oil before hand The springs, and everything are OK. No damage.....greatly relieved and thankful for the help on this forum The take away....make sure the magazine out before any movement is attempted.....