LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Holster Forum

Reply
Thread Tools Display Modes
Unread 11-11-2003, 10:40 AM   #1
USMC
User
 
Join Date: Nov 2003
Location: APG, Maryland
Posts: 75
Thanks: 0
Thanked 0 Times in 0 Posts
Post Is this holster a repro????

I'm looking to purchase a supposably "original" WWI/WWII Luger holster. It is all black and has no visable markings, and the stitching is good.

Was it common for these holsters to not have any markings, or should there be some sort of mark?

Thanks,
USMC
__________________
"We have been looking for the enemy for several days now. We found them....were surrounded! This simplifies our problem of getting to these people and killing them!
USMC is offline   Reply With Quote
Unread 11-11-2003, 11:26 AM   #2
Navy
RIP
 
Navy's Avatar
 
Join Date: Jun 2002
Location: Dc 'burbs in Virginia
Posts: 2,482
Thanks: 0
Thanked 16 Times in 10 Posts
Exclamation

A completely unmarked black holster is *not* very common. This is not to say that it a re-pop, but one seldom encounters such items that aren't.

It may,might, just possibly could be a commercially made, private purchase holster.

A good way to determine relative age is the old sniff test...old leather luger holsters should have a very strong musty smell with the scent of pipe tobacco present..unless, of course, the original user was a non-smoker, which would be very rare during the period 1914-1945 in Europe.

Hope this helps.

Tom A.
Navy is offline   Reply With Quote
Unread 11-11-2003, 01:11 PM   #3
Doubs
User
 
Doubs's Avatar
 
Join Date: Jun 2002
Location: Byron, Georgia
Posts: 1,700
Thanks: 792
Thanked 1,692 Times in 555 Posts
Post

USMC, I have a black, unmarked Luger holster that was purchased in about 1956 - give or take a year or two - with a Mauser Luger in it. It is not a repro. There is a copper rivet repair to one of the belt loops that was likely done in the field. I've always thought that it was a commercial holster. The quality is quite high.
Doubs is offline   Reply With Quote
Unread 11-11-2003, 06:54 PM   #4
lugerholsterrepair
Moderator
Lifetime Forum
Patron
 
lugerholsterrepair's Avatar
 
Join Date: Jun 2002
Location: Arizona/Colorado
Posts: 7,772
Thanks: 4,940
Thanked 3,124 Times in 1,434 Posts
Post

USMC, Marks alone will tell you nothing and might mislead you to believe it is something it may not be.

As Tom says the smell test is a good indicator but only one of many. As with any antiquity it is important to know what you are looking for. There are charecteristics that cannot be faked and you must know what these are to determine authenticity.

If you have access to Jan Still's wonderful books, there are four of them, you can take a good look at original holsters. Bender's book, Luger Holsters and Accesories will also show you some of the finer details. Look at both the front and the back. In particular the stitching patterns on the back.

Repro holsters are generally made with little attention to detail and after close inspection it will immediately become obvious that the details will be absent. The thread used on repro's is mostly cotton or synthetic. The Germans used only linen and it is corded if you look closely. The cotton will be fuzzy and the synthetic will be tight and shiney.

Often on repro holsters I have noticed the closure buckles are made of a smaller diameter wire than originals.

If you get a chance to hold an original in your hands look it over , inside and out. Vintage original holsters quality will stand out every time. Jerry Burney
__________________
Jerry Burney
11491 S. Guadalupe Drive

Yuma AZ 85367-6182


l[email protected]

928 342-7583 (CO & AZ) Year Round
719 207-3331 (cell)


"For those who Fight For It, Life has a flavor the protected will never know."
lugerholsterrepair is offline   Reply With Quote
Unread 11-12-2003, 09:48 AM   #5
Lugerdoc
Patron
LugerForum
Patron
 
Lugerdoc's Avatar
 
Join Date: Jun 2002
Location: POB 398 St.Charles,MO. 63302
Posts: 5,089
Thanks: 6
Thanked 736 Times in 483 Posts
Post

USMC, The only repro holster that I'm aware of that sometimes fools even the experts, is one made in the 1970s in Germany for the 4" barrelled Mauser Parabellum. It is of the Police type "pull down" strap closure. TH
__________________
Tom Heller POB 398 ST.Charles, MO. 63302
Tel 636-447-3006 [email protected]
Lugerdoc is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:31 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Lugerforum.com